flitchSplifter

Input Signal goes thru an envelope detector. Adjust the env-detector speed (attack + release) with the first 2 parameters. Use the slider on the right to establish the threshold level. When the env.detector level exceeds threshold, the input signal gets recorded. Use the size (3rd) parameter to control the buffer size. The Rep (repeat) parameter controls how many time the buffer gets playd back after recording. The Smth parameter smooths the buffer loop. Wet = Dry/Wet mix, Bits = Bit reduction.
The step sequencer can be used to offset the size parameter sequentially.
Note: the sequencer is not synced to host, it is trigered/stepd truh by audio-input (env.detector / threshold).
Filters: There are multimode filters (lp,bp,hp) to filter the signal before the env. detector (pre) and after it (post).

Midi Control

FlitchSplifter can be played via midi notes. To do so, activate the button on the bottom (Midi-Note-Control..). Now use your keyboard to play the buffersize:-).
Note->RecordStart.. button: Activate to start recording into buffer when midi note arrives.
Repeat till NoteOff button: Activate for endless buffer play till note off.System requirementsVST host