Groove Analogizer

Groove Analogizer is an "audio controlled drum synthesizer", it means that like a vintage electronic drum tone generator (e.g. Simmons) the percussion sound is triggered by an audio input, not by a MIDI message. This also means that you must not load, in the host, Groove Analogizer as a VST instrument, it loads as a VST effect, usually in an insert slot.
But its really a synth: the sound of three oscillators is triggered and shaped by the audio input in many ways.

How triggering works in Groove Analogizer:

A trigger can be any kind of percussive sound, both mono or stereo, it can be a wav file or another VST instrument.
For each of the three generators you can choose left, right or left+right input, input can be both mono or stereo, then a band pass filter allows you to select (coarse and fine) which frequency range of the audio source will be used for triggering, this way you can separate hi, mid and low tones in the audio input, allowing you to isolate different trigger patterns from the same complex audio source (e.g. you can input a full drums loop and select snare for trigger 1, bass drum for trigger 2 and hihat for trigger 3).
Groove Analogizer also features Pre-Listening (PL button), so that you can monitor which part of the source is selected as trigger.
Another control at the input named Sensitivity allows to fine select the loudest triggers filtered by the band pass.
Here are some key features of "Groove Analogizer":

Sound Controls For each generator:

· Release time: amplitude and pitch envelope time
· Bending: positive or negative pitch envelope amount
· Offset : pitch base
· Timbre: from pure tone to noise, with FM option.

Output Controls For each generator:

· Effect: send to internal stereo delay
· Pan: stereo image
· Volume: output level

Master Controls:

· FM: global amount
· Smooth: slope time for all envelopes
· Delay effect controls
· Dry: output of the trigger (source audio)
· Master : output level of all three generators
Requirements:

Minimal:

· 200 MHz MMX CPU
· 64 MB RAM and high-quality sound card.
· Screen settings: 800x600, high colors (16 bit), 30 MB of free hard disk space.

Suggested:

· 1000 MHz MMX and SSE CPU
· 256 MB RAM,
· Screen settings: 1024x768, true colors (32 bit),
· An ASIO soundcard is recommended for low latency real-time play.
NOTE: In order to activate this product, you will need to use the free serial key from the website.