MidiMaster

Once MidiMaster is connected in your host between the Midi In and a multitimbral VSTi or some VST instruments set to different receiving midi channels, you can:
- split or layer your keyboard in two zones, defined by the left zones highest note and the right zones lowest note;
- set for each zone: the transmitting midi channel, the Program Change message to be sent on this channel, the transpose (+/- 36 semitones, i.e. +/- 3 octaves) and the volume level;
- switch off the split and use all the above-mentioned features on the whole extension of your keyboard (the "right" section will become the "main" one);
- assign, in your host, all the knobs, sliders and the switch to CC messages, so that you can move them from your "real" master keyboard (if any);
- save and load up to 128 of these settings and pass from one to another on the fly (useful in a live performance).
Moreover you can make the Program Change drop list of each zone showing only the programs numbers (moving the relevant switch on the "internal" position) or also the name of each program (moving the relevant switch on the "file" position); in the latter case the name of the selected program is shown (in the picture: "Acoustic Bass" for the left section and "Bright Acoustic Piano" for the right section). By default MidiMaster shows the General MIDI (GM2) instruments names, loaded from the "midimaster.mmf" file; but you can easily create different files wih the programs names of your VST instruments and load them into MidiMaster using the "Load" buttons of each section (it is possible to load different programs files for each section of MidiMaster).System requirementsVST host