Shuttle-Echo

The Shuttle-Echo VST plugin was developed to be a delay device that focuses on inperfections in the repeats. Especially good for slap-back stuff & wild echo madness (the delay-time can be modulated).
Controls:
The MONO-mode does NOT distort the original stereo-image. Each channel has its own delay-chain, in mono-mode they both use the same settings.
TIME: delay time
FEEDBACK: amount of repeats
250 ms/750 ms: maximum delay time
-TIME MOD-
This feature modulates the delay time. The slider activates the effect & sets how much the delay time is affected.
SINE/S&H: Selects between a sinewave or sample & hold LFO. (sample & hold changes to a random delaytime value at the rate of the speed control)
-FLUTTER-
Pitch modulation effect (applied to the repeats only). The slider activates the effect & sets the mix.
SINE/S&H: Selects between a sinewave or sample & hold waveform. (sample & hold creates random pitch changes at the rate of the speed control)
-FILTER-
The slider activates & controls the mix of the filter.
FREQ: Cutoff frequency
RES: Resonance
HIGHPASS/LOWPASS: Filter-mode
-DRIVE-
Overdrive (applied to the repeats only). The slider activates & controls the dry/wet mix.
DRIVE: amount of drive (waveshape)
TRHESH: Threshold. This sets the level where the waveshaping occurs (increases volume with high drive settings).
PRE FILTER/POST FILTER: puts the drive-section before or after the filter.
MIX: Dry/wet mixSystem requirementsVST Host